Stryker Boats - Premium Inflatable Boats from British Columbia, Canada
0
Stryker Inflatable Boats Launching Wheel Install

Stryker Inflatable Boats Launching Wheel Install

Required Tools

  • 1×14 mm Socket Wrench
  • 1x Phillips Screwdriver
  • 1x Power Drill
  • 1×5/16 Drill bit

Hardware

  • 4 x 50 mm Stainless Bolts
  • 4 x Washers
  • 4 x Locking Washers
  • 2 x Launching Wheels
  • 2 x Launching Wheel Brackets
1

Step 1

Fully inflate all the tubes then proceed to lift the transom approximately 10 inches off the ground.

2

Step 2

Place bracket on aluminum transom and measure 1.5 inches from tow bracket. (If you do not have a tow bracket measure 3″ from tube.)

3

Step 3

Drill your top hole then place a level against the side of your bracket while you mark you bottom hole. Remove bracket and drill bottom hole.

4

Step 4

Apply a ring of silicone around holes on bracket, then firmly press bracket into place and tighten down bolts.

5

Step 5

Place both brackets on the transom and firmly press down. Then proceed to tighten down both.

6

Step 6

Clip your wheels onto their brackets. You can also flip them up while in the water.

NEED HELP CHOOSING YOUR BOAT?

NEW - 0% monthly installment payments now available at checkout! Boats ship after final payment.